1. When a vehicle enters a two-way tunnel, the driver should turn on ________.

A. The hazard lights

B. The high beam light

C. The fog light

D. The width light or the low beam light

Answer：D

2. Whats the meaning of this sign?

A. the distance from the tunnel exit

B. the distance from the tunnel entry

C. the distance of following the vehicle in front in the tunnel

D. the whole length of the tunnel

Answer：A

3. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. wait to turn left

B. pull over

C. turn right

D. reduce speed and pass slowly

Answer：C

4. What is this manipulation device?

A. switch of windscreen wiper

B. switch of the head lights

C. switch of the turn signal

D. switch of defogger

Answer：A

5. A front tire blowout is very dangerous. The vehicle will immediately turn to the side where the tire is blown out and have a direct impact on the drivers control of the steering wheel.

A. Right

B. Wrong

Answer：A

6. How to use lights when changing to the left lane on road?

A. turn on the right-turn signal in advance

B. not need to turn on any turn signal

C. turn on the left-turn signal in advance

D. turn on the low beam lights in advance

Answer：C

7. When discovering a vehicle behind wanting to overtake while driving, the driver should _______.

A. Maintain the original speed

B. Reduce speed, observe and run by the right side to yield

C. Speed up and go ahead by the right side

D. Not yield

Answer：B

8. What marking is the yellow road surface in the center of the intersection?

A. central circle

B. guide line

C. cross-hatched marking

D. parking area

Answer：C

9. When a motorized vehicle goes at night through an intersection that has no traffic lights, the driver should not use the high and low beam lights alternately.

A. Right

B. Wrong

Answer：B

10. Whats the meaning of these white rectangle markings?

A. long time parking

B. time limited parking

C. free parking

D. special parking

Answer：B

11. Driving across the double solid lines is _______

A. rule-breaking act

B. violation of law

C. faulty act

D. violation of regulations

Answer：B

12. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road entry

D. road exit marking

Answer：A

13. It lights to indicate that ______

A. front and rear width lights light on

B. front and rear width lights light on

C. left-turn signal flashes

D. right-turn signal flashes

Answer：D

14. Whats the meaning of this guide arrow?

A. no passing

B. driving lane

C. merging

D. going straight

Answer：D

15. The main impact of the road conditions at night on safe driving is ________.

A. The visibility is low and unfavorable for observing road traffic conditions

B. The road surface is complex and changing

C. The physical strength of the driver decreases

D. The driver can easily have impulse and illusion

Answer：A

16. When encountering slow-moving vehicles at an intersection that has no traffic signals, the motorized vehicle should pass alternately.

A. Right

B. Wrong

Answer：A

17. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer：B

18. When the light switch is rotated to the position, the whole car lights turn on.

A. Right

B. Wrong

Answer：B

19. The oil pressure of engine may be too high if it lights.

A. Right

B. Wrong

Answer：B

20. When a motorized vehicle runs in a foggy weather, the driver should turn on the fog light and the hazard lights.

A. Right

B. Wrong

Answer：A

21. A driver should buckled up before the vehicle moves.

A. Right

B. Wrong

Answer：A

22. At night, the drivers observation is markedly poorer than in the daytime and the range of visibility range is _______.

A. Unchanged

B. Irregular

C. Longer

D. Shorter

Answer：D

23. Traffic Signs and traffic markings are not traffic signals.

A. Right

B. Wrong

Answer：B

24. Whats the meaning of this sign?

A. Passing on both sides

B. Passing is prohibited

C. Passing by the left side

D. Passing by the right side

Answer：A

25. What is the max speed when passing this curve?

A. 40km/hr

B. 30km/hr

C. 50km/hr

D. 70km/hr

Answer：B