黄南科目四英语pdf

1. Whats the meaning of the marking in the red circle?

A. temporary stopping

B. large bus stopping

C. bus station

D. emergency stopping

Answer:C

2. What kind of violation does this broken down vehicle have?

A. not turn on the hazard lights

B. not stop the car by the roadside

C. not solve the problem at once

D. not place the warning sign

Answer:D

3. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road entry

D. road exit marking

Answer:A

4. Move the turn signal switch upward, the left-turn signal lights.

A. Right

B. Wrong

Answer:B

5. What marking are the white broken lines in the circles?

A. small vehicles turning lines

B. lane connection lines

C. non-motorized vehicles guide lines

D. intersection guide line

Answer:D

6. A motorized vehicle driver who drives after drinking is subject to a ________.

A. 3-point penalty

B. 2-point penalty

C. 6-point penalty

D. 12-point penalty

Answer:D

7. This sign reminds there is a ferry ahead for vehicles.

A. Right

B. Wrong

Answer:A

8. Turn on the right-turn signal and return immediately to the original lane afterovertaking.

A. Right

B. Wrong

Answer:B

9. It lights to remind that the driver‘s seat is not adjusted properly.

A. Right

B. Wrong

Answer:B

10. In which situation cannot overtake a vehicle in front?

A. vehicle in front is reducing speed to yield

B. vehicle in front is turning left

C. vehicle in front is pulling over by the roadside

D. vehicle in front is turning right

Answer:B

11. What is this traffic sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer:A

12. How to use lights at this position?

A. turn on the right-turn signal

B. turn on the left-turn signal

C. turn on the hazard lights

D. turn on the head lights

Answer:B

13. Speed up when passing the overflowing road.

A. Right

B. Wrong

Answer:B

14. Driving a motorized vehicle shall not overtake in tunnels, steep slopes and other special sections.

A. Right

B. Wrong

Answer:A

15. Continuously using the foot brake on a long downhill road ________.

A. Can shorten the engines service life

B. Increases the drivers labor intensity

C. Can drastically reduce the braking efficiency due to the rising temperature of the brake

D. Can easily cause vehicle overturn

Answer:C

16. How to pass when encountering this situation at the intersection?

A. make sure it is safe to pass

B. turn right and speed up to pass

C. speed up and pass straight

D. turn left and speed up to pass

Answer:A

17. Whats the meaning of the yellow mark on the road?

A. no going straight

B. allowed to make a U turn

C. no U turn

D. no making a turn

Answer:C

18. Full penalty points of a scoring cycle because of violating the traffic regulations is 12 points.

A. Right

B. Wrong

Answer:A

19. When the tire pressure is too low, the fast-running tire can change its shape like waves and increase its temperature, which in turn can cause ________.

A. Even lower tire pressure

B. Increases resistance to the vehicle

C. Tire blowout

D. Unstable tire pressure

Answer:C

20. It is a bad habit for a driver to put his left arm on the window of the vehicle or hold the gear lever in his right hand for a long time.

A. Right

B. Wrong

Answer:A

21. If a motorized vehicle runs 50% faster than the specified speed limit, the driver is subject to a 3-point penalty.

A. Right

B. Wrong

Answer:B

22. A motorized vehicle is not allowed to make a U turn at the level crossing, bridge, steep slope, tunnel or dangerous road section.

A. Right

B. Wrong

Answer:A

23. Whats the meaning of this sign?

A. no entry for bicycles

B. lane for non-motorized vehicles

C. special lane for bicycles

D. bicycle stopping area

Answer:B

24. Whats the meaning of this sign?

A. slippery section

B. sharp curve

C. test driving section

D. curve section

Answer:A

25. What mark is the inclined yellow and black lines?

A. entity mark

B. protrusions mark

C. three-dimensional mark

D. deceleration mark

Answer:C