马鞍山英文科目四考试题库

1. How to run at this position when leaving the expressway?

A. enter the deceleration lane

B. keep running forward

C. keep the speed at 100km/hr

D. reduce the speed to less than 40km/hr

Answer:A

2. When a vehicle goes uphill on a mountain road, it should change to a lower gear in a timely, accurate and rapid manner so as to avoid a situation in which driving at a high gear can reduce the power of the engine.

A. Right

B. Wrong

Answer:A

3. Whats the meaning of this sign?

A. turn left

B. no going straight

C. straight-going lane

D. one-way road

Answer:A

4. Within the validity of the Admission Form, the times of test reservation for Driving Skills of subject 2 and subject 3 can not exceed ______

A. 3 times

B. 4 times

C. 5 times

D. 6 times

Answer:C

5. If a person who has caused a major traffic accident and if his act constitutes a crime, he may not be held for criminal liabilities.

A. Right

B. Wrong

Answer:B

6. You may speed up to go through the intersection in this case.Answer:

A. Right

B. Wrong

Answer:B

7. The braking system may malfunction if it lights.

A. Right

B. Wrong

Answer:A

8. When a vehicle changes lane, the driver should turn on the turn signal and rapidly enter the new lane.

A. Right

B. Wrong

Answer:B

9. Before a vehicle enters an intersection, the driver should reduce speed, observe and make sure it is safe to do so.

A. Right

B. Wrong

Answer:A

10. What is the max speed on this highway?

A. 30km/hr

B. 40km/hr

C. 50km/hr

D. 70km/hr

Answer:D

11. It lights to indicate that ______

A. the head fog light is turned on

B. the low beam light is turned on

C. the high beam light is turned on

D. the tail fog light is turned on

Answer:C

12. Whats the meaning of this sign?

A. no U turn

B. no changing to left lane

C. no turning left

D. no entering the left lane

Answer:C

13. When encountering a traffic jam on the expressway, the driver should follow the front vehicle lining up, and immediately turn on the hazard light to prevent rear-end collision.

A. Right

B. Wrong

Answer:A

14. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer:B

15. When a vehicle leaves an expressway, it should reduce speed in the deceleration lane before entering the ramp.

A. Right

B. Wrong

Answer:A

16. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road exit

D. road exit marking

Answer:D

17. Which kind of vehicle can be driven if the authorized vehicle applied for is small motor vehicle?

A. low-speed truck

B. midsize bus

C. motor tricycle

D. self-propelled wheeled machinery

Answer:A

18. Whats the meaning of the marking in the red circle?

A. temporary stopping

B. bay-stopping

C. emergency stopping

D. public bus station

Answer:B

19. It lights to indicate that ______

A. the floor and the front fans work

B. air internal circulation

C. air external circulation

D. the side and the floor fans work

Answer:A

20. You should speed up through the section with this kind of traffic marking.

A. Right

B. Wrong

Answer:B

21. When passing a section of a mountain road which is prone to landside and mudflow, the driver should not stop.

A. Right

B. Wrong

Answer:A

22. When reaching a sharp curve, the driver should reduce speed and drive on the right side so as to avoid colliding with the vehicle crossing the central line of the curve in the opposite direction.

A. Right

B. Wrong

Answer:A

23. Whats the meaning of the white markings on the road?

A. road construction marking

B. horizontal deceleration marking

C. vertical deceleration marking

D. fewer lanes indication marking

Answer:B

24. Whats the meaning of this sign?

A. minimum speed limit is 50km/hr

B. maximum speed limit is 50km/hr

C. the height is 50m

D. the altitude is 50m

Answer:A

25. ABS system can maximize the braking efficiency when conducting _______

A. braking intermittently

B. braking continuously

C. applying emergency braking

D. gently depressing the brake pedal

Answer:C