1. Driving in a dusty weather, it does not needed to turn on the head light, the contour light and the tail light.

A. Right

B. Wrong

Answer：B

2. This sign reminds the road in front changes to inseparate two ways section.

A. Right

B. Wrong

Answer：A

3. Whats the meaning of this sign?

A. no U turn

B. no changing to left lane

C. no turning left

D. no entering the left lane

Answer：C

4. What pedal is it?

A. accelerator pedal

B. clutch pedal

C. handbrake

D. the brake pedal

Answer：A

5. Whats the meaning of this sign?

A. hump bridge

B. high outburst road

C. low-lying road

D. bump road

Answer：A

6. A motorized vehicle can make a U turn on this road as long as it does not interfere other vehicles.

A. Right

B. Wrong

Answer：A

7. This sign indicates landslide section ahead and bypassing.

A. Right

B. Wrong

Answer：B

8. The main impact of mountain roads on safe driving is _______.

A. The traffic conditions are boring

B. The slopes are long, the curves are sharp and visibility range is shorter.

C. The traffic flow is heavy

D. The road signs are fewer

Answer：B

9. When a following vehicle gives the overtaking signal, the driver should ________ if conditions permit.

A. Move to the right side and speed up

B. Voluntarily reduce speed and drive along the right side

C. Yield a proper space and speed up

D. Reduce speed rapidly or apply an emergency braking

Answer：B

10. When a motorized vehicle goes at night through an intersection that has no traffic lights, the driver should not use the high and low beam lights alternately.

A. Right

B. Wrong

Answer：B

11. When encountering stopping in turn or slow-moving vehicles in front at an intersection where lanes are reduced, the motorized vehicle should _________.

A. enter the intersection from road shoulder by the right side of the vehicle in front

B. enter the intersection from the side of interspace

C. pass alternately with one vehicle each lane to enter the intersection

D. change to left lane and cut in to enter the intersection

Answer：C

12. When driving in thick or extremely thick fog, the driver should ____ due to low visibility.

A. Turn on the head light and keep driving

B. Turn on the contour light, fog light and drive along the right side

C. Turn on the hazard lights and keep driving

D. Turn on the hazard lights, fog light, and stop at a safe place

Answer：D

13. Whats the meaning of this sign?

A. going straight and right turn

B. going straight and left turn

C. no going straight and no left turn

D. right turn and left turn only

Answer：B

14. May speed up to go through the crosswalk in this situation.

A. Right

B. Wrong

Answer：B

15. Whats the meaning of the diamond broken lines on the road?

A. road construction marking

B. vertical deceleration marking

C. horizontal deceleration marking

D. fewer lanes indication marking

Answer：B

16. Violating the law and regulations on road traffic safety is the act of violation of the law.

A. Right

B. Wrong

Answer：A

17. The cycle for recording the accumulated penalty points for violating road traffic regulations is ____________.

A. 14 months

B. 12 months

C. 6 months

D. 10 months

Answer：B

18. When a vehicle goes uphill, the driver should observe the road conditions and the length of the slope in advance and shift to the lower gear in a timely manner to ensure the vehicle has sufficient power.

A. Right

B. Wrong

Answer：A

19. The validity of the driving license is divided into 6-year, 10-year and 20-year.

A. Right

B. Wrong

Answer：B

20. When a vehicle stops for a long time, the driver should select a car park to do so.

A. Right

B. Wrong

Answer：A

21. Whats the meaning of this sign?

A. no entering the intersection

B. no right turn

C. no changing lane

D. no U turn

Answer：B

22. Whats the meaning of this sign?

A. bump road

B. high outburst road

C. low-lying road

D. hump bridge

Answer：B

23. The hazard lights can be used when ________

A. encountering traffic congestion

B. following a vehicle on road

C. the vehicle breaks down and stops

D. leading the vehicle behind

Answer：C

24. When a vehicle changes lane before an intersection, the driver should do so ______.

A. In the area marked by solid lines before the intersection

B. In the area marked by solid lines in the intersection

C. In the area marked by broken lines as indicated by the guide arrow

D. Before the stop line at the intersection

Answer：C

25. What marking is the white solid lines in the circle?

A. guide lanes lines

B. variable guide lanes lines

C. direction guide lines

D. one-way driving lines

Answer：A