1. Whats the meaning of this sign?
A. right-turn lane
B. U turn lane
C. left-turn lane
D. lanes for going in different directions
Answer：C
2. When driving slowly in a congested road, the driver should ________ if another vehicle forcefully cuts in.
A. Honk to warn it against cutting in
B. Speed up to closely follow the vehicle in front and refuse to allow it to cut in
C. Squeeze the cutting-in vehicle to force it to leave
D. Voluntarily yield to ensure safe driving
Answer：D
3. When a vehicle goes uphill, the driver should observe the road conditions and the length of the slope in advance and shift to the lower gear in a timely manner to ensure the vehicle has sufficient power.
A. Right
B. Wrong
Answer：A
4. What is the meaning of this sign?
A. provincial highway No.
B. national highway No.
C. county road No.
D. township road No.
Answer：A
5. When a vehicle enters a two-way tunnel, the driver should turn on ________.
A. The hazard lights
B. The high beam light
C. The fog light
D. The width light or the low beam light
Answer：D
6. Whats the meaning of this sign?
A. township road No.
B. county road No.
C. provincial highway No.
D. national highway No.
Answer：D
7. The main impact of mountain roads on safe driving is _______.
A. The traffic conditions are boring
B. The slopes are long, the curves are sharp and visibility range is shorter.
C. The traffic flow is heavy
D. The road signs are fewer
Answer：B
8. Honking in a foggy day can arouse the attention of the opposite side. After hearing the honking from the opposite side, the driver should also honk to respond.
A. Right
B. Wrong
Answer：A
9. Whats the meaning of this sign?
A. special car park
B. uncovered car park
C. indoor car park
D. internal car park
Answer：C
10. Whats the meaning of this sign?
A. lane information indication
B. road branching point ahead
C. place and distance indication
D. intersection ahead
Answer：D
11. When passing an unmanned level crossing, the driver should ________.
A. Speed up and pass
B. Reduce speed and pass
C. Maintain the speed and pass
D. Stop, look and pass
Answer：D
12. Whats the meaning of this guide arrow?
A. no passing
B. driving lane
C. merging
D. going straight
Answer：D
13. Displays the current speed is 20 km / h
A. Right
B. Wrong
Answer：B
14. What marking is the white polylines in the circle?
A. ascertaining the distance between the vehicles
B. driving at reduced speed
C. ascertaining the speed of the vehicles
D. reducing the speed at the intersection
Answer：A
15. What marking is the combination of the white broken lines and the triangle area?
A. road entry marking
B. lane-dividing line that can be crossed
C. deceleration line at road exit
D. road exit marking
Answer：D
16. After a vehicle enters the ramp, the driver should swiftly increase the speed to more than 60 kilometers per hour.
A. Right
B. Wrong
Answer：B
17. You may speed up to go through the intersection in this case.Answer：
A. Right
B. Wrong
Answer：B
18. The vehicle can not run straight or turn left in this situation.
A. Right
B. Wrong
Answer：A
19. Whats the meaning of this sign?
A. exit and entry for disabled people
B. watch for disabled people
C. rest area for disabled people
D. special passage for disabled people
Answer：B
20. Whats the meaning of this sign?
A. U turn lane
B. bypassing lane
C. lanes for going in different directions
D. left-turn lane
Answer：A
21. What marking is it?
A. A cross-hatched marking
B. prohibitive area
C. guide line
D. central circle
Answer：D
22. Which is correct when changing lane?
A. turn on the directional signal and turn left quickly
B. reduce speed properly when entering the left lane
C. cannot interfere other vehicles
D. speed up to enter the left lane
Answer：C
23. Whats the meaning of this sign?
A. 3.5m width limit
B. 3.5m width limit ban is lifted
C. 3.5m distance from vehicles limit
D. 3.5m height limit
Answer：D
24. What does this symbol indicate?
A. switch of high beam lights
B. switch of the low beam lights
C. master switch of vehicle lights
D. the switch of tail fog light
Answer：C
25. When a vehicle passes a level crossing, the driver should use the low gear to pass and should not change gear halfway in order to avoid engine kill.
A. Right
B. Wrong
Answer：A
