1. When driving at night on a road with no or poor lighting, the driver should switch from the low beam light to the high beam light. But the vehicle following in the same direction is not allowed to use the high beam light.
A. Right
B. Wrong
Answer：A
2. A motorized vehicle is not allowed to stop in the section 50 meters to the bridge, steep slope or tunnel.
A. Right
B. Wrong
Answer：A
3. What marking is the combination of the white broken lines and the triangle area?
A. road entry marking
B. lane-dividing line that can be crossed
C. deceleration line at road entry
D. road exit marking
Answer：A
4. This set of the hand signals of the traffic police indicates that the vehicles should ___ .
A. wait to turn left
B. pull over
C. turn right
D. reduce speed and pass slowly
Answer：C
5. May stop temporarily in the lane for non-motorized vehicles in this section.
A. Right
B. Wrong
Answer：B
6. It lights to indicate that ______
A. left-turn signal flashes
B. front and rear width lights light on
C. front and rear width lights light on
D. right-turn signal flashes
Answer：A
7. When reversing on an ordinary road and discovering some vehicles are passing, the driver should _________.
A. Honk to indicate the intention
B. Voluntarily stop and yield
C. Speed up and reverse
D. Continue to reverse
Answer：B
8. It lights to indicate that ______
A. windscreen wash lacks
B. braking oil lacks
C. cooling system malfunction
D. coolant lacks
Answer：D
9. This sign warns the driver to run slowly with care and beware of the vehicles from horizontal road.
A. Right
B. Wrong
Answer：A
10. It lights when ABS is open.
A. Right
B. Wrong
Answer：B
11. This set of the hand signals of the traffic police indicates that the vehicles should ____ .
A. reduce speed and pass slowly
B. pull over
C. stop
D. turn right
Answer：D
12. Whats the meaning of this sign?
A. lane for small vehicles
B. special lane for small vehicles
C. special lane for multi-passenger vehicles
D. lane for motorized vehicles
Answer：D
13. Which part does it control when pulling this switch?
A. turn signals
B. reverse light
C. contour light
D. hazard light
Answer：A
14. What is this manipulation device?
A. switch of reverse light
B. switch of wiper
C. switch of the hazard lights
D. combination switch of lights and signals
Answer：D
15. When a vehicle reaches a sharp curve, the driver should _______.
A. Brake suddenly and go slowly
B. Drive along the outer side of the curve
C. Fully reduce speed and drive on the right side
D. Go forward by borrowing the opposite lane
Answer：C
16. When overtaking on a mountain road, the vehicle should overtake ______.
A. By taking every possible chance
B. By selecting a wide gentle uphill section
C. By selecting a fairly long downhill section
D. By selecting a relatively gentle downhill section
Answer：B
17. The rear windshield defroster starts to work after pressing this switch.
A. Right
B. Wrong
Answer：B
18. Whats the meaning of this sign?
A. provincial highway No.
B. county road No.
C. township road No.
D. national highway No.
Answer：C
19. When the two red lights at a level crossing flash alternately, the vehicles should stop to wait.
A. Right
B. Wrong
Answer：A
20. The light switch is in this position, front fog lights turn on
A. Right
B. Wrong
Answer：A
21. The subject 3 test is divided into two parts including Driving Skills, Common Knowledge on Safe and Courteous Driving.
A. Right
B. Wrong
Answer：A
22. Whats the meaning of this sign?
A. bypass from right side
B. one-way passing
C. watch for danger
D. bypass from left side
Answer：A
23. Whats the meaning of this sign?
A. watch for long time honking
B. an unmanned level crossing
C. a manned level crossing
D. multi-crossing of railway and road
Answer：B
24. Whats the meaning of this sign?
A. fewer lanes
B. merging point
C. emergency lane
D. changing to left lane
Answer：A
25. Before the motorized vehicle runs on the road, the driver should check the safety and technical performance of the vehicle.
A. Right
B. Wrong
Answer：A
