1. What marking is the two white broken lines in the circle?

A. stop lines at crossroad

B. left-turn waiting areas

C. U turn guide lines

D. small vehicles turning lines

Answer：B

2. Which part does it control when rotating this part of the switch?

A. the low beam lights

B. the head and tail fog lights

C. high beam lights

D. turn signals

Answer：B

3. A vehicle running on an expressway may frequently change lanes.

A. Right

B. Wrong

Answer：B

4. Whats the meaning of this mark on the road?

A. the lane for non-motorized vehicles

B. the special lane for motorcycles

C. the special lane for battery bicycles

D. the special lane for bicycles

Answer：A

5. When bicycles ahead obstruct the traffic flow, the driver may honk to remind them,speed up and bypass.

A. Right

B. Wrong

Answer：B

6. When a motorized vehicle breaks down on the road and is difficult to move, the driver should place a warning sign within 50 meters behind the vehicle.

A. Right

B. Wrong

Answer：B

7. The validity of the driving license which is initially applied for is 4 years.

A. Right

B. Wrong

Answer：B

8. It lights to indicate that ______

A. charge current is too large

B. damaged battery

C. ammeter malfunction

D. charging circuit malfunction

Answer：D

9. A vehicle should try to speed up after starting from the roadside and rapidly turn left into the traffic flow on the road.

A. Right

B. Wrong

Answer：B

10. After a vehicle enters the ramp, the driver should swiftly increase the speed to more than 60 kilometers per hour.

A. Right

B. Wrong

Answer：B

11. What is this traffic sign?

A. slippery section

B. sharp curve

C. inverse curve

D. continuous curves

Answer：C

12. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer：B

13. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn right

B. reduce speed and pass slowly

C. pull over

D. change lane

Answer：D

14. Whats the meaning of the white markings on the road?

A. road construction marking

B. horizontal deceleration marking

C. vertical deceleration marking

D. fewer lanes indication marking

Answer：B

15. May directly turn left in front of the vehicle coming opposite when encountering this traffic light.

A. Right

B. Wrong

Answer：B

16. It lights to remind that engine oil needs to be filled.

A. Right

B. Wrong

Answer：B

17. When following a vehicle on the road, the distance from the vehicle in front is not important. As long as the driver goes forward at the same speed as the vehicle in front does, he can avoid rear-end collision.

A. Right

B. Wrong

Answer：B

18. What does this symbol indicate?

A. luggage compartment is opened

B. door of one side is opened

C. engine compartment is opened

D. cover of fuel tank is opened

Answer：A

19. The driving license of a motorized vehicle driver will be detained after his penalty scores reach 12 points in a scoring circle.

A. Right

B. Wrong

Answer：A

20. Whats the meaning of this sign?

A. no yielding

B. yield while crossing each other

C. reduce speed and yield

D. stop to yield

Answer：C

21. If the applicant commits bribery or cheating in the course of a test, his eligibility for this test will be cancelled and the results of other tests he has passed will be invalid.

A. Right

B. Wrong

Answer：A

22. Whats the meaning of this sign?

A. special lane for small vehicles

B. special lane for motorized vehicles

C. special lane for taxis

D. special lane for multi-passenger vehicles

Answer：D

23. When encountering stopping and waiting in turn or slow-moving vehicles in front, the motorized vehicle may _________.

A. borrow road to overtake

B. occupy the opposite lane

C. follow the vehicles in front

D. cut in the waiting vehicles

Answer：C

24. Whats the meaning of this sign?

A. bump road

B. high outburst road

C. low-lying road

D. hump bridge

Answer：B

25. When starting up a vehicle stopping at the roadside, the driver should first ________.

A. Depress the accelerator pedal and start

B. Honk

C. Increase engine rotation speed

D. Observe the conditions around the vehicles

Answer：D