梅州英语驾考科目四考试

1. Which is correct in this kind of intersection?

A. make a U turn along the left lane

B. cannot make a U turn

C. make a U turn through the middle lane

D. make a U turn inside the intersection

Answer:B

2. When starting up a vehicle stopping at the roadside, the driver should first ________.

A. Depress the accelerator pedal and start

B. Honk

C. Increase engine rotation speed

D. Observe the conditions around the vehicles

Answer:D

3. Whats the meaning of this sign?

A. intersection ahead

B. interchange ahead

C. Y-shaped intersection ahead

D. ring intersection ahead

Answer:B

4. Whats the meaning of this sign?

A. section narrows on both sides

B. section for speed test

C. section for ascertaining the distance between the vehicles

D. pay attentions to keeping distance

Answer:D

5. Whats the meaning of this sign?

A. Y-shaped intersection

B. T-shaped intersection

C. intersection

D. ring intersection

Answer:B

6. Let the straight-going vehicle go first at this intersection.

A. Right

B. Wrong

Answer:A

7. Do not hang or place articles close to the front and rear windows that block the vision of the driver.

A. Right

B. Wrong

Answer:A

8. When driving, the driver should be courteous and defensive, instead of being offensive.

A. Right

B. Wrong

Answer:A

9. How to run when encountering this situation?

A. speed up to enter the lane of either side

B. enter the right lane

C. reduce speed and enter the lane of either side

D. can not run in the lane of neither side

Answer:D

10. How to use lights at this position?

A. turn on the right-turn signal

B. turn on the left-turn signal

C. turn on the hazard lights

D. turn on the head lights

Answer:B

11. This set of the hand signals of the traffic police indicates that the vehicles should ____ .

A. turn right

B. change lane

C. reduce speed and pass slowly

D. pull over

Answer:C

12. Continuously using the foot brake on a long downhill road ________.

A. Can shorten the engines service life

B. Increases the drivers labor intensity

C. Can drastically reduce the braking efficiency due to the rising temperature of the brake

D. Can easily cause vehicle overturn

Answer:C

13. When a motorized vehicle goes at night through an intersection that has no traffic lights, the driver should not use the high and low beam lights alternately.

A. Right

B. Wrong

Answer:B

14. What mark is the inclined yellow and black lines?

A. entity mark

B. protrusions mark

C. three-dimensional mark

D. deceleration mark

Answer:C

15. When a vehicle goes down a long slope, it should run at a lower gear and fully use the engine to brake.

A. Right

B. Wrong

Answer:A

16. It lights to indicate that ______

A. the head and tail fog lights are turned on

B. front and rear width lights are turned on

C. the head lights are turned on

D. the hazard lights are turned on

Answer:B

17. Whats the meaning of the yellow broken and solid lines in the middle of the road?

A. no crossing the lines on the side of the broken line

B. no crossing the lines on the side of the solid line

C. allowed to cross the lines on the side of the solid line

D. allowed to cross the lines on both sides

Answer:B

18. When driving in a heavy rain, the driver should control the speed to avoid the danger arising from water slide.

A. Right

B. Wrong

Answer:A

19. Whats the meaning of the white horizontal solid line in the circle?

A. turning waiting line

B. deceleration line

C. yielding line

D. stop line

Answer:D

20. What is this manipulation device?

A. switch of the turn signal

B. switch of the head lights

C. switch of wiper

D. switch of defogger

Answer:D

21. When a vehicle changes lane, the driver should turn on the turn signal in advance,observe traffic conditions, maintain a safe distance and move into the new lane.

A. Right

B. Wrong

Answer:A

22. How to pass this intersection?

A. keep the speed and go through

B. honk to urge

C. reduce speed and go through slowly

D. speed up and go through

Answer:C

23. When a motorized vehicle breaks down at night, and is difficult to move, the driver should turn on the hazard lights, the contour lights and the tail lights.

A. Right

B. Wrong

Answer:A

24. When crossing each other at night, how far should change the high beam lights to low beam lights?

A. not need to change lights

B. beyond 150m

C. within 100m

D. within 50m

Answer:B

25. What is the max speed on muddy road?

A. 15km/hr

B. 20km/hr

C. 40km/hr

D. 30km/hr

Answer:D