1. Whats the meaning of the diamond broken lines on the road?

A. road construction marking

B. vertical deceleration marking

C. horizontal deceleration marking

D. fewer lanes indication marking

Answer：B

2. It lights when turning on the front high beam lights.

A. Right

B. Wrong

Answer：B

3. When a vehicle overtakes the bike riders going in the same direction, the rational way to deal with is to ________.

A. Continuously honk to remind them to yield

B. Continuously honk and speed up to overtake

C. Yield to the bike riders

D. Observe them, reduce speed and go slowly, while keeping a sufficient safe distance.

Answer：D

4. It lights to indicate that engine oil may be insufficient.

A. Right

B. Wrong

Answer：A

5. When a vehicle is being overtaken by another vehicle, and there is a vehicle following behind, the driver should _____.

A. continue to speed up and run

B. turn slightly to the right side, keep a safe horizontal distance

C. run by road center

D. speed up to the right side to yield

Answer：B

6. Driving a motorized vehicle on the highway which has no central line, the maximum speed can not exceed 70 kilometers per hour.

A. Right

B. Wrong

Answer：B

7. When discovering traffic congestion ahead while driving, the driver should ________.

A. Find a chance to overtake the vehicle in front

B. Weave through other vehicles

C. Reduce speed, stop and wait in line

D. Honk to urge other vehicles

Answer：C

8. When overtaking a vehicle stopping on the right side, the driver should ________ in case that vehicle starts up suddenly or opens the door.

A. Speed up and pass

B. Keep honking

C. Maintain the normal speed

D. Keep a safe horizontal distance from that vehicle, reduce speed and pass

Answer：D

9. This sign reminds dangerous hillside road ahead.

A. Right

B. Wrong

Answer：B

10. The subject 3 test is divided into two parts including Driving Skills, Common Knowledge on Safe and Courteous Driving.

A. Right

B. Wrong

Answer：A

11. What kind of marking is the yellow broken line in the center of the road?

A. indicative marking

B. prohibitive marking

C. warning sign

D. auxiliary marking

Answer：A

12. The rear windshield defroster starts to work after pressing this switch.

A. Right

B. Wrong

Answer：B

13. When a vehicle reaches a muddy or burst-and-muddy section, the driver should stop,observe and select the level and solid section or the section with vehicle tracks.

A. Right

B. Wrong

Answer：A

14. Speed up when passing the overflowing road.

A. Right

B. Wrong

Answer：B

15. This sign reminds bump road ahead which may causes bump phenomenon.

A. Right

B. Wrong

Answer：A

16. It lights to indicate that ______

A. the head and tail fog lights are turned on

B. front and rear width lights are turned on

C. the head lights are turned on

D. the hazard lights are turned on

Answer：B

17. How to drive in sand, hail, rain, fog, ice and other weather conditions?

A. run as normal

B. maintain the speed

C. speed up properly

D. reduce the speed

Answer：D

18. What is this manipulation device?

A. switch of the turn signal

B. switch of the head lights

C. switch of wiper

D. switch of defogger

Answer：D

19. When a vehicle encounters a bike rider coming in the opposite direction on the road, the driver should _________.

A. Continuously change the high and low bean lights

B. Continuously honk

C. Use the low beam light, reduce speed or stop to evade

D. Use the high beam light

Answer：C

20. When passing a section of a mountain road which is prone to landside and mudflow, the driver should not stop.

A. Right

B. Wrong

Answer：A

21. When a vehicle runs on a narrow mountain road, the driver should ______ if the party close to the mountain mass refuses to yield.

A. Honk to urge the other party to yield

B. Maintain the normal speed

C. Reduce speed or stop to yield

D. Use the left lane and pass with care

Answer：C

22. How to do while entering this intersection?

A. shift the high and low beam lights alternately to remind the cars already in the intersection to yield

B. quickly cut in the cars already in the intersection

C. let the cars already in the intersection go first

D. honk and enter directly

Answer：C

23. Before the motorized vehicle runs on the road, the driver should check the safety and technical performance of the vehicle.

A. Right

B. Wrong

Answer：A

24. How to drive through the intersection without traffic lights?

A. reduce speed and go slowly

B. speed up and pass

C. let large vehicle go first

D. let the left vehicle go first

Answer：A

25. When a motorized vehicle stops temporarily at the roadside, the driver ________.

A. Is not allowed to stop in the opposite direction or in parallel

B. May stop anyway he likes as long as it is convenient for him to get out

C. May stop the vehicle in the opposite direction

D. May stop the vehicle in parallel

Answer：A