1. The validity of the driving license which is initially applied for is 6 years.
A. Right
B. Wrong
Answer：A
2. How to pass this intersection?
A. not reduce speed to pass
B. speed up to pass as soon as possible
C. slide over in the neutral gear
D. reduce speed or stop to observe
Answer：D
3. Whats the meaning of this sign?
A. fewer lanes
B. merging point
C. emergency lane
D. changing to left lane
Answer：A
4. Motorized vehicles should pass the intersections according to the traffic signals.
A. Right
B. Wrong
Answer：A
5. It lights to indicate that ______
A. the tail fog light is turned on
B. the low beam light is turned on
C. the high beam light is turned on
D. the head fog light is turned on
Answer：A
6. How to use lights when changing to the left lane on road?
A. turn on the right-turn signal in advance
B. not need to turn on any turn signal
C. turn on the left-turn signal in advance
D. turn on the low beam lights in advance
Answer：C
7. When a motorized vehicle crosses a non-motorized vehicle on a narrow road or a narrow bridge at night, the motorized vehicle should use the high beam light.
A. Right
B. Wrong
Answer：B
8. When bicycles ahead obstruct the traffic flow, the driver may honk to remind them,speed up and bypass.
A. Right
B. Wrong
Answer：B
9. What should a motorized vehicle has while running on the road?
A. a label of keeping distance
B. a label of reminding danger
C. a label of inspection
D. a label of product qualification
Answer：C
10. One can drive the low-speed truck if the authorized vehicle applied for is small motor vehicle with automatic transmission.
A. Right
B. Wrong
Answer：B
11. Whats the meaning of this sign?
A. crosswalk lights
B. watch for pedestrians
C. attention to traffic lights
D. intersection
Answer：C
12. Which is correct to use lights on rainy day when following a vehicle?
A. use high beam lights
B. cannot use the low beam lights
C. cannot use the high beam light
D. use fog lights
Answer：C
13. What is this traffic sign?
A. slippery section
B. sharp curve
C. inverse curve
D. continuous curves
Answer：D
14. The oil pressure of engine may be too high if it lights.
A. Right
B. Wrong
Answer：B
15. What device does the switch of this symbol control?
A. the windscreen defrosting or defogging
B. the rear window wiper and washer
C. the windscreen wiper and washer
D. the rear window defrosting or defogging
Answer：C
16. When driving at night, the driver should reduce speed and go forward if the vehicle coming in the opposite direction fails to turn off the high beam light. This is designed to prevent an accident from happening when there are pedestrians crossing the place where the lights of the two vehicles meet.
A. Right
B. Wrong
Answer：A
17. When a vehicle stops temporarily in a snowy day, the driver should turn on _______.
A. The head and tail fog light
B. The reserve light
C. The high beam light
D. The hazard lights
Answer：D
18. When a motorized vehicle makes a U turn, turns around or goes down a slope, the maximum speed should not exceed 40 kilometers per hour.
A. Right
B. Wrong
Answer：B
19. What is this manipulation device?
A. air conditioner switch
B. ignition switch
C. wiper switch
D. light switch
Answer：B
20. When driving, the driver should be courteous and defensive, instead of being offensive.
A. Right
B. Wrong
Answer：A
21. It lights continuously to indicate that airbag is working.
A. Right
B. Wrong
Answer：B
22. The act of this small passenger vehicle to enter the expressway lane is correct.
A. Right
B. Wrong
Answer：B
23. It lights to indicate that ______
A. the head and tail fog lights are turned on
B. front and rear width lights are turned on
C. the head lights are turned on
D. the hazard lights are turned on
Answer：B
24. When crossing each other on a narrow road, the driver should slow down, yield and stop first.
A. Right
B. Wrong
Answer：A
25. You should speed up to go through the railway crossing in this case.
A. Right
B. Wrong
Answer：B
