1. It lights to indicate that ______
A. front and rear width lights light on
B. front and rear width lights light on
C. left-turn signal flashes
D. right-turn signal flashes
Answer：D
2. Driving this kind of vehicle on road is ____
A. rule-breaking act
B. violation of regulations
C. violation of law
D. criminal act
Answer：C
3. Cannot make a U turn in this section.
A. Right
B. Wrong
Answer：A
4. This sign reminds embankment road ahead.
A. Right
B. Wrong
Answer：B
5. How to go straight when encountering this traffic light at the intersection?
A. enter the intersection to wait
B. turn left
C. speed up and pass straight
D. can not exceed the stop line
Answer：D
6. Whats the meaning of this sign?
A. more vehicles section
B. passing slowly
C. jammed section
D. construction section
Answer：B
7. According to rules on the road traffic safety, the maximum speed on the expressway is less than 120km/hr, thus, it will not be in violation of the traffic regulations as long as the speed does not exceed 120km/hr on the expressway.
A. Right
B. Wrong
Answer：B
8. Whats the meaning of this sign?
A. slippery section
B. sharp curve
C. test driving section
D. curve section
Answer：A
9. Driving a motorized vehicle shall not overtake in tunnels, steep slopes and other special sections.
A. Right
B. Wrong
Answer：A
10. Whats the meaning of this sign?
A. watch for long time honking
B. an unmanned level crossing
C. a manned level crossing
D. multi-crossing of railway and road
Answer：B
11. When a vehicle enters a two-way tunnel, the driver should turn on ________.
A. The hazard lights
B. The high beam light
C. The fog light
D. The width light or the low beam light
Answer：D
12. When the two red lights at a level crossing flash alternately, the vehicles should stop to wait.
A. Right
B. Wrong
Answer：A
13. What is the max speed when passing this curve?
A. 40km/hr
B. 30km/hr
C. 50km/hr
D. 70km/hr
Answer：B
14. How to use lights at this position?
A. turn on the right-turn signal
B. turn on the left-turn signal
C. turn on the hazard lights
D. turn on the head lights
Answer：B
15. Which part does it control when pulling this switch?
A. turn signals
B. reverse light
C. contour light
D. hazard light
Answer：A
16. What kind of marking is the yellow broken line in the center of the road?
A. indicative marking
B. prohibitive marking
C. warning sign
D. auxiliary marking
Answer：A
17. Whats the meaning of this sign?
A. fewer lanes
B. merging point
C. emergency lane
D. changing to left lane
Answer：A
18. When reaching an intersection, the driver should _____ if a turning vehicle cuts in.
A. Stop to evade
B. Maintain the normal speed
C. Speed up and pass ahead of it
D. Honk and pass ahead of it
Answer：A
19. You can make an U turn at this intersection.
A. Right
B. Wrong
Answer：B
20. Whats the meaning of this sign?
A. section narrows on both sides
B. section for speed test
C. section for ascertaining the distance between the vehicles
D. pay attentions to keeping distance
Answer：D
21. How the front vehicle to run in this situation?
A. run as normal
B. yield
C. turn on the hazard lights
D. should not change lane
Answer：B
22. The double yellow solid lines in the middle of the road are used to separate the traffic flow in opposite directions, crossing the lines to overtake or make a turn is allowed if it is safe.
A. Right
B. Wrong
Answer：B
23. Stop the vehicle and observe when reaching the level crossing in this situation.
A. Right
B. Wrong
Answer：A
24. Whats the meaning of this sign?
A. bypass from right side
B. one-way passing
C. watch for danger
D. bypass from left side
Answer：A
25. A motorized vehicle runs on the road without a label of inspection, the traffic police can detain the vehicle.
A. Right
B. Wrong
Answer：A
